En MS3 V3 med ett MS3X expanderkort, byggd av ExtraEfi-Philip i England. Kabelstammarna är sprillans nya (inköpta maj) från DIYAutoTune.com, Kablarna är 3 meter långa.
MS-lådan satt i min bubbla en sommar och går som en dröm. Det fattas en liten skruv i ena hörnet på lådan och en som ska hålla kontakten i DB9kontakten. Usb-kabel finns också.
Lite info om MS3/MS3X:
VE and ignition tables are both 16 x 16 with full interpolation.
0.1% steps on VE table, 0.1 degree steps on ignition table
Socket for an onboard SD card – no laptop required for data logging (SD Card not included)
Built in USB port
GM stepper IAC control
Closed loop idle and mixture control
CANBus communications for interface with GPIO Board, IO Extender, or other devices
Staged injection
Native support for many different OEM trigger patterns
With MS3X expansion board installed, enabling the following features:
8 Sequential fuel injection outputs. Each can drive a high impedance injector, and unused injection outputs can be put to other purposes.
8 Logic level 5 volt ignition outputs. Works with many types of ignition modules and coils, including LSx coils and our IGN-1As. Requires external module or coils with internal ignitors.
6 Medium current outputs. Use for 2 stage progressive nitrous, boost control, tach output, 3 wire idle speed control, general purpose PWM or relay control, or many other potential applications.
3 Analog inputs. Use for an external MAP sensor, second O2 sensor, fuel pressure, accelerometer, or general data logging.
4 Switch inputs. Can be used to start data logging, arm a nitrous system, switch tables, launch control, VSS input (Hall sensor or VR with external conditioner), and more.
1 Cam sensor input. Can be used with VR, Hall, or optical sensors.
Kablarna:
10′ of TXL High temp automotive grade wire.
Color coded wiring with labeling printed on the wire every 6 inches
Pris 4000kr inkl frakt.
Maila helst på [email protected] eller ring/sms 0761095104
