Shimsen...hur var det nu?

är det detta du söker?

In this image you will see a diagram of a drop spindle.
this image has A, B, C and D Arrows that are pointing at shims in-between each side of the link pins. These shims are used to help the link pin move with less friction and to true up any difference in the off set of the trailing arm position verses the king pins position.
(These shims are not here to set or adjust the camber; camber/caster is preset from the factory if your camber is off you probably have a bigger problem).
Refer to image (C)
This image shows you the amount of spacer shims needed to properly mate your spindles to the trailing arms.
You will first need to measure how much more the bottom trailing arm protrudes from the beam than the top one it is usually 3 -8 mm more than the top.
You can usually measure this with a straight ruler laid across the bottom trailing arm shim surface pointing up over the top trailing arm shim surface.
You can use image (B) in correlation with image (C) to determine the amount of shims needed.

Är det inte samma schimstabell oberoende om man kör droppade spindlar eller ej.

Det har jag fått för mig. Annars har jag schimsat helt fel.